Analysis of the causes of overheating during honing tube processing
1. The honing tube and stuffing box are skewed during assembly, causing local friction with each other, and should be adjusted in time;
2. The holding spring of the sealing ring is too tight and the friction is large, so it should be adjusted appropriately;
3. The axial clearance of the sealing ring is too small, and the axial clearance should be adjusted according to the regulations;
4. The oil supply is insufficient and the oil supply should be increased appropriately;
5、Honing tubeThe running-in with the sealing ring is not good, and the running-in should be increased during grinding;
6. Impurities mixed in gas and oil should be cleaned and kept clean.